If there are several inseminators on the farm, then it can be useful to record and monitor. Here, we will give you a short explanation of the settings and where you can see the check the results later.
Step 1: Go to 1.9 Supplier list
In the Supplier List, the inseminators must be added. To do so click [New] at the bottom left and make sure to enter something in the fields Name and Herd Number and that below Type the box is ticked for [Operator]. Finally, click on [OK]:

Step 2: Go to system Settings-General settings
Then you go to [Cow calendar] and the tab [Serving] and make shure that this box is ticked:

You can fill in the three entry fields below if you have a specific preferred code / inseminator
Step 3: Entering insemination (s) at Daily entry
From now on, when you enter an insemination in daily events, there will be an item added at the end: the inseminator code. There you can add the inseminator (code) for each breeding.
Step 4: Review results
If you’ve been working with entering inseminatons for a while in this way, then it is also be useful to see the results. Go to 3.11 Fertility KPI’s (US). In the second tab, the [Conception Rate], it is possible to group by inseminator code (bottom left). Also in 3.7 Insemination analysis under the button [Summary], the results per inseminator will be shown.